Image: www.grips4less.com

Every golfer knows the importance of a well-fitted putter grip. Not only does it provide comfort and control, but it can also impact your putting performance significantly. If you’re looking to switch out your Super Stroke putter grip for a different one, it’s essential to do it correctly. This step-by-step guide will provide you with the detailed instructions you need to remove your Super Stroke putter grip safely and effectively.

Materials you’ll need:

• Screwdriver with a Phillips head
• Utility knife
• Solvent (e.g., rubbing alcohol, acetone)
• Cloth or paper towels
• New putter grip (optional)

Step 1: Remove the Shaft Collar

Start by locating the shaft collar on the putter. This is a small, metal ring that connects the shaft to the grip. Using a Phillips head screwdriver, carefully loosen the screw on the collar. Once the screw is loose, you can remove the collar.

Step 2: Cut the Grip

Now, it’s time to cut the Super Stroke grip. Take your utility knife and carefully cut along the edge where the grip meets the shaft. Be sure to only cut through the grip and not the shaft. You should make a circular cut around the entire grip.

Step 3: Peel Back the Grip

Once you’ve cut through the grip, you can start peeling it back. Use your fingers or a flathead screwdriver to gently lift the edge of the grip and peel it away from the shaft. As you peel, be careful not to tear the grip or damage the shaft.

Step 4: Remove the Excess Adhesive

After removing the grip, there may be some excess adhesive left on the shaft. This can prevent the new grip from adhering properly. Use a solvent-soaked cloth or paper towels to clean the shaft thoroughly. Be sure to only use the solvent on the shaft, not on the new grip.

Step 5: Install the New Grip (Optional)

If you have a new putter grip, you can now install it. Start by applying a small amount of adhesive to the shaft. Then, slide the new grip onto the shaft, making sure it’s aligned correctly. Finally, tighten the shaft collar to secure the grip.

Tips for a Clean Removal:

• Use a sharp utility knife for a clean cut.
• Peel the grip back slowly and carefully to avoid tearing.
• Clean the shaft thoroughly to remove excess adhesive.
• If the grip is stuck, you can use a heat gun or hair dryer to soften the adhesive.

Conclusion

Replacing a Super Stroke putter grip is a relatively straightforward process that you can easily do at home. By following the steps outlined in this guide, you can safely remove your old grip and install a new one, ensuring better comfort, control, and putting performance on the green. Whether you’re looking to customize your putter or simply upgrade your grip, don’t hesitate to tackle this task with confidence.

Image: www.youtube.com

How To Remove Super Stroke Putter Grip